team associated RC8bE

[NitroXray80809]

hey i have one questions for you. i cant explain it in words ill have to post pics. but its about these little plastic pieces that fit in side the hing pin holder. one side adjust the TOE while the other idk it just moves the hing pin up and down. do you know what that other adjustment is and how it affects the car?

Those are kick up adjusting shims. Normally if your not a real heavy tune guy and just race here and there club lever use the one thats in the middle. They change the angle of the hinge pin for slight tune to gain steering or handling on track conditions.

[dizzyinzo]

so should i just put it dead center or in the middle?

[NitroXray80809]

so should i just put it dead center or in the middle?

in the center.

[dizzyinzo]

ok thanks man. and is 3deg toe in rear fine?

[NitroXray80809]

ok thanks man. and is 3deg toe in rear fine?

i dont know with ae but you want just a lil toe in where your front tire bow out from each other just a little. I would say neg 1 or 2 would be a better set up.

[dizzyinzo]

my conversion should be in the mail today. i think the servo tomorrow. and then ill be picking up the motor mount this coming up weekend at the LHS

[NitroXray80809]

my conversion should be in the mail today. i think the servo tomorrow. and then ill be picking up the motor mount this coming up weekend at the LHS

Nice, you should enjoy it. Just keep an eye on bearings and always tear it apart after every 3 to 5 race days to inspect real good. E doesnt get dirty as fast so most skip over that and will wear extreamly fast when it could of just been a bad bearing.

[dizzyinzo]

ok thanks.... i like to clean and just oil my car grease the gears change the oils. about every month. i dont race a lot so it doesnt get used to much

[NitroXray80809]

ok thanks.... i like to clean and just oil my car grease the gears change the oils. about every month. i dont race a lot so it doesnt get used to much

Yeah it will be fine. You will notice the diffrence in a quality car!

[RCRacing88]

Looking good man

I've come to a halt with my buggy haha I shimmed the diff wrong so lets just say I need a few new parts

Bet ya can't wait to get your up and running!