Reply With Quotedoes the grub srcew come out of pinon?
LinkBack URL
About LinkBacks
My pinion on my ERB will not stay on the shaft. I've gone through 4 spur gears because it will slip up and strip all the teeth off of it. I've tried red superglue on it, still slipped. Is the pinion messed up??
2nd Place is the 1st Loser
E Revo Mamba Monster 2200kv
Slash 2WD Stock with Homemade Swaybars
Youtube Account:
[url]http://www.youtube.com/user/TheChris1696?feature=mhum[/url]
does the grub srcew come out of pinon?
Nope. Idk whats wrong, I haven't drove it in like a month cause I can't fix it.
E Revo Mamba Monster 2200kv
Slash 2WD Stock with Homemade Swaybars
Youtube Account:
[url]http://www.youtube.com/user/TheChris1696?feature=mhum[/url]
you might just need to get a new pinion maybe
Yeah, that's probably what I'm going to do.
E Revo Mamba Monster 2200kv
Slash 2WD Stock with Homemade Swaybars
Youtube Account:
[url]http://www.youtube.com/user/TheChris1696?feature=mhum[/url]
a pinions the cheapest way to go and i usually carry about three when i run my car
Don't forget,before you install the new pinion take and clean the grub screw with rubbing alcohol then let it dry. Apply some blue locktite. Install pinion and tighten grub screw. Don't drive RC for 24 hours. This is to let the thread lock dry! Good luck and be patient!
Sent from my iPad using Tapatalk HD
loctite only takes about 5 mins to dryOriginally Posted by dirty don
How many r/c's do i have?
1 Stampede Monster Mutt edition
3
4
5
6
7
8
9
10
Empty spaces = none YET!
it takes 5 miuntes to be dry to the touch. but 24hours is the best way to go so it will be as hard as it can.
Rustler VXL with $754.10 worth of upgrades (and more to come)
Helion 1/18 animus 18sc with custom LED headlights & taillights and a 4050kv 4pole brushless motor
Kyosho Jet Stream 800 needing esc
Posting Permissions
Support Menu - Find what you're looking for fast!
