new integy motor problem

[mossycrawlerscx10]

I was breaking in my integy 35t,after the first break in session i took it apart for inspection all looked well.after the second session i took it apart again,all still looked well so i put it back together. I pulled the trigger on my controller and it is having trouble spinning,however it spins freely by hand. i noticed on the side opposite the pinion gear side it seems to be hanging up there for some reason. any ideas?

[mossycrawlerscx10]

i found out it was my brushes.

[BSRC]

Do you know what caused the damage?

Sent from my Galaxy S via Tapatalk

[mossycrawlerscx10]

Do you know what caused the damage?

Sent from my Galaxy S via Tapatalk

i think it was from taking it apart to inspect the putting it back together.Thats all that i can think,they are the small ones on the side opposite the pinion gear shaft side. i should have taken better care when disassembling and reassembly, in my opinion was a newb mistake.

[BSRC]

ah ok. Mistakes are nothing more than self education.

Sent from my Galaxy S via Tapatalk

[erevofreak96]

yep, integy stuff is usually pretty good

[batman]

what are you runnin it in?

[mossycrawlerscx10]

what are you runnin it in?

I was gonna run it in my scx10.

[andersonwal]

The problem is that he is using stuff from Integy. lol