Mad >:(

[rcbeginner]

if you have products that mess up good customer service is very important

[erevofreak96]

ya, but it must have been a freak thing,cuz ive had the thing for a while and no probs with it, untill now

[jestedsniper]

I feel the same way right now. Anyone have any suggestions about replacing a stock VXL-3 speed controller? I have the 1/16th scale Boss 302, and unfortunately I have burned the ESC from doing high speed runs. I wasn't that concerned with it since its stock though so no biggie. I need something that can handle a lot of voltage since I'm running 14.4 volts, but I don't need something crazy expensive. Any ideas? Low voltage cut-off doesn't matter since i don't run LiPO. So if it has it great if not, no big deal. I may start a thread, so I don't hi-jack this one, but leave info in either place.

Glad Castle decided to replace your ESC, hopefully this one lasts you a little bit longer than the first one...