RC Ramps

[TheChris1696]

Do ya'll have any suggestions on building a good rc ramp? Cardboard, wood, plastic, etc. Also if you do I need the dimensions to understand it better!

[crazybearrc]

Yes, get a box and cut out one side of it so that side slants down and tape it togther to the sides of the box so that it stays in place without breaking.

[TheChris1696]

I've tried that but I can't get a big enough box and the tape always comes apart because too much grass gets on the sticky part.

[rcbeginner]

you can also get those big folders from any office supply store and doublesided tape the ends together so they wont come apart

[jeremy]

I would recommend just getting a nice skateboard ramp. They really are not that expensive, they are portable, and made of strong material.

[camo11]

idk if they make them any more but a couple years ago they had some plastic black ones that were ment for bikes. skateboards... they work really well.

[TheChris1696]

idk if they make them any more but a couple years ago they had some plastic black ones that were ment for bikes. skateboards... they work really well.

I have two of those ramps with the middle piece but I need another one.

[SAHerps]

I just use a board and a few 2x4's to build one.

[TheChris1696]

I just use a board and a few 2x4's to build one.

I was thinking 2X4's with plywood so i'll have a bend to the ramp.

[crazybearrc]

I was thinking 2X4's with plywood so i'll have a bend to the ramp.

Or scrap model. You need to be creative, make it a one of a kind.