Results 1 to 3 of 3

Thread: Duratrax Evader clutch

  1. #1
    Junior Member
    Join Date
    Mar 2013
    Posts
    1

    Question Duratrax Evader clutch

    A friend of mine bought a Duratrax Evader and 3 batteries later the clutch is done.
    The esc is linkable via Castle Link, so it is possible to ease the power back a bit but the clutch is still a problem.
    I have heard that a Traxxas Slash 2wd slipper will fit on it.
    Has any one done this and if so how well did it fit?

  2. #2
    Senior Member
    Join Date
    Nov 2012
    Location
    Red Lodge, UK
    Posts
    124
    Was it new or used? Either way, it sounds like the slipper was too loose. Look in the manual and find the correct way to adjust it, I don't have one so I don't know if the Slash slipper will fit.

    Sent from my GT-I9300 using Tapatalk 2

  3. #3
    Senior Member rcman's Avatar
    Join Date
    Nov 2011
    Location
    Hartland, Wisconsin
    Posts
    847
    idk about if the slash slipper will fit but the original slipper clutch was too lose. you need to tighten the slipper clutch nut all the way down, and then loosen it 1/2 of a turn. that should be good. What do you mean by "the clutch is done"?
    If nobody comes back from the future to stop you, how bad of a decision can it be?
    -Traxxas Rustler VXL
    -Axial SCX10 Jeep Wrangler

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •