Drive your engine in water?

[Niro]

If u drove your engine in the water by acident and none of the servos work... open everything especially the recivers and dry it, with a hair dryer or a blower. dry everything..open your engine and clean it with fuel. than when your done put it back together.. start it and have fun
Niro

[FREDALRIC]

Yes dry it out. If it does not help. Maybe you fried your reciever.

[traxxas5308]

that will probably work for sure on the engine if done right away. the servos on the other hand dry those off to. if there is no corrosion on the circuit boards it should work. (i think don't quote me on the servo part)

[BSRC]

Use contact cleaner to remove the water from the engine and after-run oil to relube. Open all the electronics to expose the circuit boards and put them in a bowl of white rice. The rice will absorb any moisture.

[KawasakiDude572]

i was watching some videos and the truck rolled over backwards in the mud and water does that hurt the engines i couldnt imagine it wouldnt but they kept going could you guys help me with this?

[crazybearrc]

If u drove your engine in the water by acident and none of the servos work... open everything especially the recivers and dry it, with a hair dryer or a blower. dry everything..open your engine and clean it with fuel. than when your done put it back together.. start it and have fun
Niro

Arent you Nirokiller from YT

[Spy1238]

I drove my 1/16 summit in water and my water proof reciver box wasnt fully on and it stopped working. I took it apart let it sit out for a couple of days. put it back together and it worked perfectly. Drying is the key!