Problems with SC10

[BlitzHPI]

Ok so I noticed yesterday that my truck wasn't driving straight. I tried trimming it out but it didn't get any better. Then I noticed that the left steering knuckle looked odd. I don't what to look for or how to fix it. Any help would be greatly appreicated. Thanks fellas.

[rcbeginner]

make sure each tierod on the steering is the same length on each side

[JatoTheRipper]

Why do you say the knuckle looks odd?

Sent from my ADR6300 using Tapatalk

[BlitzHPI]

Cause it looked like it's bent or somethin idk lol

[BlitzHPI]

Will do. Didn't think about it too much. Thanks bub

[Carpet Racer]

Ok so I noticed yesterday that my truck wasn't driving straight. I tried trimming it out but it didn't get any better. Then I noticed that the left steering knuckle looked odd. I don't what to look for or how to fix it. Any help would be greatly appreicated. Thanks fellas.

Are you serious? You don't want to look for or how to fix it? I know this is a forum to help people but that is just shear laziness. You gotta learn your truck. I've had mind for a week or so and know it inside and out. Not trying to be mean, someone won't always be there to help.

[Guy_With_RC]

Are you serious? You don't want to look for or how to fix it? I know this is a forum to help people but that is just shear laziness. You gotta learn your truck. I've had mind for a week or so and know it inside and out. Not trying to be mean, someone won't always be there to help.

Thats a little harsh Carpet, some people that are new to the RC might not see the little details that would make something not run right, or over look something because it does not look broken so they don't look into it. I know when I started I asked ALOT of stupid questions, but questions are never stupid or lazy in anything someone does. The only thing someone will gain from questions is KNOWLEDGE.....

As for the question....just like "rcbeginner" stated... check your toe and tie rods, or check to make sure your castor block is not cracked or that the pin is bent.....Take everything apart(on the 1 side) check it out and compare to the opposite side then replace if needed!

Seems as this is an old posting.........What was your issue with the steering? how did you fix it?

[sc10maniac]

i have also had issues with my sc10...and advise about puddles???